Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I want to deny this IP range                 10.25.0.1 – 10.25.0.255                10.25.1.1 – 10.25.1.255 Permit only 1 host                 10.25.7.136  255.255.255.192  Using access-list. ( Current configuration  ) ip nat inside source list 101 i...

joel.palen by Community Member
  • 1731 Views
  • 2 replies
  • 0 Helpful votes

Hi, We have a customer site and datacentre. On the customer site there is  accesss Switch and ASA firewall, from the firewall we have a ISP link and P2P link connected to Switch on our datacentre.                                                      ...

cawaafe79 by Community Member
  • 1087 Views
  • 3 replies
  • 0 Helpful votes

Good Morning,We would like to update our Network infrastructure which has the fallowing equipment and softwareCisco Router ( C3900-UNIVERSALK9-M)Cisco Switch (C2960-LANBASE-M)Cisco ASA ( 5525- version 8.6(1)2 ) with a VPN Premium licenseCisco CallMan...

I've got an ASA with two "outside" interfaces and twelve "inside" interfaces.I'd like to separate the Access Lists between outside access and inside access. By default I'd like the inside interfaces access to the internet and nothing else and then bu...

carlos.garza by Community Member
  • 1116 Views
  • 3 replies
  • 0 Helpful votes

Hi,I would like to know how can I rollback the VDB version on FireSIGHT aka Defence Center? Assume my current VDB is 248 and I would like to rollback to 246. Please advice. Thanks. Regards,Zaw Min Oo

zaw.minoo by Community Member
  • 1586 Views
  • 0 replies
  • 0 Helpful votes

Hi Team, My customer using ASA5510 firewall and they'll have Internet(outside) interface migration, i need to bring up the secondary internet now before the migration. I intend to use available interface but found license is limited to max 4 interfac...

I am trying to setup a failover ASA 5505 to provide HA to current ASA 5505 in production. The following is current failover setup:###############################failoverfailover lan unit primaryfailover lan interface failover Vlan3failover key *****f...

guanbowen by Frequent Visitor
  • 1225 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card