Hello
I'm trying to figure out if I need any access-list or NAT rules in order to communicate with networks advertised over the OSPF configuration. I have a third party connection coming into my Cisco ASA 5520. Please refer to my configuration below. It appears that the traffic is leaving from my side but not return back from the third party connection. They are doing the NAT on my network as the traffic arrives in their network. The route table on the firewall shows all the network from the OSPF route. Since I have same-security-traffic permitted, I don't think I need any extra configuration for my traffic from VLAN 10 to hit any networks from OSPF. Need some insight on this issue. Thanks.
interface GigabitEthernet0/1
description LAN
nameif Inside
security-level 100
no ip address
!
interface GigabitEthernet0/1.10
description LAN Servers
vlan 10
nameif LAN
security-level 100
ip address 192.168.4.1 255.255.255.0
!
interface GigabitEthernet0/2
description Third Party Connection
nameif Third Party Conn
security-level 100
ip address 10.16.1.5 255.255.255.252
!
router ospf 1
router-id 10.16.1.5
network 10.16.1.6 255.255.255.252 area 0
area 0
log-adj-changes
redistribute connected subnets
redistribute static
!
same-security-traffic permit inter-interface
same-security-traffic permit intra-interface
