ā05-31-2019 05:23 AM
Hi,
I am facing an Active/active failover problem
model ASA 5525
system image: asa922-4-SMP-k8.bin
ASDM: 7.2(2)1
both firewall configuration matched. and interface showing up. but failover is not working.
any one help this..
ā05-31-2019 05:41 AM
Here is a link to a document showing the configuration.
Here is a configuration example.
ā06-02-2019 04:23 AM
It looks like you may be monitoring the SFR/IPS module as part of the failover, which has failed on the primary firewall. It is in recover mode.
If you provide the output of
Show run all monitor-interface
If you see the module as being monitored, just negate it with the no command until you figure out what is wrong with the module. This will at least get your failover working.
ā06-03-2019 01:01 AM
just to add what @GRANT3779 said.
he is right follow his instruction. moreover, it seems your SFR could be problemetic. might you need to re-image this module. however, recover should come in to state as UP/UP. otherwise, do some test no sucess than reimage this.
ā06-05-2019 03:41 AM
We not using IPS module. Both firewalls is up. but failover not happened where is primary down.
ā06-05-2019 04:13 AM
What is the Output from
show run all monitor-interface
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide