cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1338
Views
0
Helpful
1
Replies

ASA 5525-X and user creation

georgehewittuk1
Level 1
Level 1

Hi,

I've remoted onto a device and I'm struggling to understand if I am actually on the firepower module or if it is integrated with the ASA. It could be that I am using an older version of code which is confusing me.

 

Cisco ASA5525-X Threat Defense Software 6.1.0

 

When I console in -

"Cisco Fire Linux OS v6.1.0 (build 37)
Cisco ASA5525-X Threat Defense v6.1.0 (build 330)"

The command line is different to that of a normal ASAv 9.8 and Cisco IOS (which I am better experienced in.) When trying to configure a local user I can't even get into the enable/configure global mode. Is there a way in seeing if I am on the firepower module as I am struggling to source an IP address of the FW - I am trying to make another local user & when i go into the running configuration I can't see the local user we access this device with & there is no aaa configuration.

 

Thanks

 

1 Reply 1

Sheraz.Salim
VIP Alumni
VIP Alumni

"Cisco Fire Linux OS v6.1.0 (build 37)
Cisco ASA5525-X Threat Defense v6.1.0 (build 330)"

you have console in to the FTD and  in FTD console you can not go into the privi mode to change/edit setting. In order for you to do you may need to go into the GUI of this FTD or if this is managed by FMC than check it from there.

please do not forget to rate.
Review Cisco Networking for a $25 gift card