Network Security

Hi Guys Pls Find Attachment FMC 6.2.3 FTD 6.2.0 I have AnyConnect VPN License , and it show up in FMC Smart License , but the Strange issue i m not able to assign it to FTD pls have a look to screenshoot , i put all there thanks

Dear Support, i used cisco ASA 5520 with a site-to-site to à Cisco router, the vpn is running well.recently, i decide to migrate my asa 5520 to asa 5525-x and configure the vpn on the asa 5525-x My issue is the vpn don't coming up when i back to asa ...

I have configured port Gi1/2-Gi1/8 as follows with the nameif incrementing such as inside2, inside3 etc. A small DHCP pool has been created as well.interface GigabitEthernet1/2bridge-group 1nameif inside1security-level 100When I connect my laptop to ...

Hi Guys what is Equivalent OF the below commands with regard to cisco FTD logging on logging monitor debuging thanks

I am running FTD 6.3.0 on an ASA 5516-x is there a way to factory reset the box without re-imaging it? I am testing an ASA to FTD migration.

any info when and if a ftd-cluster is planned and may be available in a virtual fmc (6.x) ?

ASA with a Cisco C2960-L with multiple vlans and Internet accessI got an ASA 5506-X running sw version 9.8 and a security plus license. It has a routed public subnet and a Cisco C2960-L switch connected to it. The switch is L2 only, running IOS LAN L...

I'm trying to access my ASA 5505 by https://192.168.1.1 but I can't. I'm using Windows 7.  I already have installed ASDM and I can enter in the box by ASDM.  I am preparing to reformat my PC and I'm afraid that I won't be able to access my ASA if I d...

We have ASA in Acitve PAssive mode. Seems Primay ASA shows failed and Secondary become active How can i console into failed primary ASA? when i console i get continous log message unable to type? From Sec ASA which is active now show failoverFailover...

I am trying to push upgrade from FMC to our Sensors, they are geographically separated by continents, the upgrade times out after 1 hour. Is there any way to increase this timeout?   Version 6.2.3   Thank you.