cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

204
Views
0
Helpful
0
Replies
Highlighted
Beginner

ASA 5585 REPEATEDLY RELOADS WITH FAILOVER CONFIG

Hello All,

We have bought new Cisco ASA 5585X Firewalls.After configuration failover active/standby it began repeatedly to reload. Both ASAs keep reloading every hour at least 2-3 times.

The failover configuration is simple, just stateful failover.


failover
failover lan unit primary
failover lan interface failover GigabitEthernet0/3
failover polltime unit 10 holdtime 30
failover polltime interface 5 holdtime 40
failover key *****
failover link failover GigabitEthernet0/3
failover interface ip failover 10.10.130.1 255.255.255.0 standby 10.10.130.2

!


failover
failover lan unit secondary
failover lan interface failover GigabitEthernet0/3
failover polltime unit 10 holdtime 30
failover polltime interface 5 holdtime 40
failover key *****
failover link failover GigabitEthernet0/3
failover interface ip failover 10.10.130.1 255.255.255.0 standby 10.10.130.2

 

 

In standby mode, without failover they do not reload, the function normally. BUt when I enable failover, they begin to keep reload repeatedly.

Did you ever meet this problem? What could cause this problem?

It is first time I meet this 

 

Best Regards

Tural Lachinov

0 REPLIES 0
Content for Community-Ad