SSP-10 in slot 0
IPS SSP-60 in slot 1
This is not a supported configuration but does it actually work?
On one chassis the system image is missing from IPS SSP-60. I attempted hw-module recovery from tftp but it just gets stuck in recovery mode. IPS SSP console says pretty much says its in boot loop because it does not have a valid image.
The procedure I used
http://www.cisco.com/en/US/docs/security/ips/7.1/installation/guide/hw_system_images.html#wp1371782
I can download the image via tftp to flash but the recovery for IPS SSP just does't load from tftp.
When there are two modules in the chassis, the management port for IPS SSP-60 comes up (green) but I don't see management 1/0 port. Is it still referenced by management 0/0 on IPS SSP console?
