Hello,
We have a pair of ASA5585 configured in HA and I am trying to understand if the ASA can do ECMP on a port that's configured with sub-interfaces. The Cisco document below describes that ECMP can only be done on the same port/interface. "Multiple static routes that utilize ECMP are available only on the same interface."
So, if I have a port-channel configured with two VLANs/sub-interfaces and have two default static routes each of which has a destination to a different next-hop IP address, would this configuration work?
Here's how I have the port-channels and static routes configured:
(IP addresses are fictitious)
!
!
interface Port-channel1.400
vlan 400
nameif outside
security-level 0
ip address 1.2.80.5 255.255.255.248 standby 1.2.80.6
!
interface Port-channel1.403
vlan 403
nameif outside
security-level 0
ip address 1.2.82.5 255.255.255.248 standby 1.2.82.6
!
!
interface GigabitEthernet0/0
description OUT
channel-group 1 mode active
no nameif
no security-level
no ip address
!
!
interface GigabitEthernet0/3
description OUT
channel-group 1 mode active
no nameif
no security-level
no ip address
!
!
https://www.cisco.com/c/en/us/support/docs/security/adaptive-security-appliance-asa-software/115986-asa-eqm-products-configuration-example.html
Thanks in advance.
~zK