Network Security

I havent been able to locate how to actually get the IPS Module active for a trial, Im able to install the image, access via ASDM/SSH, I get the Trial on the sensor itself running, but on the 5525 it shows as Disabled no matter what command I run.  W...

Hi experts,If so how to enable it? Thanks a lot in advance. Regards,

When I am configuring SSH on cisco asa 5505 for its show network address invalid.Version 8.2(5)plz help.................

is any license required on ASA 5505 for active passive configuration ?

Hello,I am hoping someone can help me out to get this VC traffic through this network. I am quite new to ASAs, and I feel I am making a tonne of headway on it (much thanks to everyone here!), just seem to be caught on this one issue.The setup: The VC...

Hi All,On Cisco ACE, can you souce NAT 1x IP address to multiple different source IP addresses where each destination is unique. So for example:Original Source = 1.1.1.1Natted Source = 2.2.2.2Original Destination = 10.10.10.1Natted Destionation = Ori...

I have an ASA 5505 and I have the three regular vlans, outside, inside and dmz. The best would be only have outside and inside and skip dmz, but without explenation there is not possible to have more then two clients in whats now dmz because of a mac...

Hi,I am able to ftp from my Head Office to my test machine at the remote location but I can't get the other way around to work. Error message from the Syslog deny tcp src 192.168.50.5/1825 dst 208.124.202.44/21 by access-group "dmz_access_in"I try a ...

Hi,I am working on translating configuration from a firewall named Joebox to ASA 5515.On Joebox, it has 5 continuous public IP addresses (xx.xx.xx.73 -77/29), first one as interface IP and others as alias, on the Internet-facing interface.I need to c...