06-30-2011 06:31 PM - edited 03-11-2019 01:53 PM
Hi Team!
I am after any advice previous experience with running ASA5585’s in active/standby across a local campus MPLS network. Supported design, leading practice etc.
Specifically our design is that two ASA5585 are configured as active/standby through a local campus MPLS network over 10gig links through ASR9k etc. The ASA’s are providing inter-vrf routing capability only with p2p l2vpn circuits configured for each logical interface between the ASA over MPLS etc.
The failover link is via a direct fibre and the state link will be through a p2p l2vpn (option for direct fibre also)
Is this a supported design to begin with? See also attached diagram.
Thanks in advance
Thomas
07-01-2011 06:09 AM
Why do you want to make both the failover & state links seperate? Just use 1 interface connected by fibre.
HTH>
07-04-2011 10:30 AM
Test to Andrew. (sorry for the SPAM Thomas)
Andrew - did this reply get echoed to your email?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: