I have a location that we acquired that has a second location connected to them via a site-to-site tunnel. We just took over management of the hardware at the second location and need to get syslog messages sent to our existing syslog server. The existing tunnel is configured to access the address space where the syslog server is located as we can ping it from a user standpoint. I am trying to figure out how to get the syslog added to the tunnel. I found a similar discussion on CCO but apparently it is so old they have pulled the documents referenced in that conversation so have nothing to compare with. I am used to being on the receiving end and have things like inside addresses but this is the sending end and only connected via the tunnel not sure where to start. Ant assistance or doc would be appreciated.
Brent
