03-03-2016 07:00 AM - edited 03-12-2019 12:26 AM
Hello,
I have site to site tunnel between 2 ASAs. One ASA is behind the university and other is at our datacenter. University provides us the Internet services and they have the ASA which controls the incoming traffic. We used to have tunnel issues where the stale SAs were inactive at University and SAs got deleted at the datacenter due to inactivity timeout or some other reasons not known. Later found out that ASA9.1.5 behind the University ASA had the bug for not deleting the stale entries. After downgrading the code to 8.4.6 version we are not seeing any issues. And its working as normal. University guy said he added some ACLS on the outside interface to allow our Datacenter public IP to pass the VPN traffic.
https://quickview.cloudapps.cisco.com/quickview/bug/CSCup37416
My Question even before adding those acls the tunnels was working but was not deleting the stale entries. I think after upgrade it became stable. Unversity guys says after adding the ACL it may have stablized the issue.
My understanding that even before adding the ACLs the university ASA used to initiate the tunnel always and hence it was working previously or there could be another reason too which i am not aware of.
Could anyone can provide insight into as what was going on?
Thanks in advance.
03-03-2016 03:46 PM
Hello,
You can check if you have the following sysopt enabled "sysopt connection permit vpn" and this will actually prevent vpn traffic to go through the inspections before getting to the inside networks.
Adding the public ip on the outside interface shouldn't make any difference whether the tunnel works or not, the tunnel will break if there's no traffic flowing through it.
One possible bug that might have been affecting you is this one:
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCty91877/?reffering_site=dumpcr
Please rate if you find the information useful.
Regards,
-Javier-
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide