10-15-2012 11:41 AM - edited 03-11-2019 05:09 PM
Hi All,
I have the network topology as mentioned in the diagram and we made the configurations as of below,
we need to get the internet failover from the firewall local isp link to the isp link of other site,
which will be reachable from the core's mpls link 192.168.252.x with the longer AD.
(AT1CORE01#ip route 0.0.0.0 0.0.0.0 192.168.252.73 185----MPLS Link)
AT1CORE01#sh ip eigrp ne
EIGRP-IPv4:(10) neighbors for process 10
H Address Interface Hold Uptime SRTT RTO Q Seq
(sec) (ms) Cnt Num
1 10.49.100.1 Vl100 12 10w2d 1 200 0 2978( Dmvpn Device)
2 10.49.91.1 Vl91 13 10w2d 1 450 0 542 ( Firewall)
0 192.168.252.73 Vl400 14 10w2d 1 200 0 1020( Mpls )
AT1CORE01#
------------------
AT1FW01# sh ip add
System IP Addresses:
Interface Name IP address Subnet mask
Method
Ethernet0/0 inside 10.49.91.1 255.255.255.0
CONFIG
Ethernet0/1 outside 38.110.x.x 255.255.255.248
CONFIG
Ethernet0/2 state 10.49.71.1 255.255.255.0
unset
Ethernet0/3.1 DMZ 10.49.70.254 255.255.255.0
CONFIG
Ethernet0/3.2 DMZ_Mgmt 10.49.51.254 255.255.255.0
CONFIG
Management0/0 failover 10.49.81.1 255.255.255.0
unset
Current IP Addresses:
AT1FW01#
router eigrp 10
no auto-summary
distribute-list eigrp_route_filter in
network 10.132.91.0 255.255.255.0
redistribute static metric 10240 1 255 1 1500 route-map static_out_filter
access-list eigrp_route_filter standard permit 10.132.91.0 255.255.255.0
access-list eigrp_route_filter standard permit 10.132.50.0 255.255.255.0
access-list eigrp_route_filter standard permit 10.132.24.0 255.255.255.0
access-list eigrp_route_filter standard permit 10.132.26.0 255.255.255.0
access-list eigrp_route_filter standard permit 10.132.16.0 255.255.255.0
access-list static_out_filter standard deny 10.2.50.0 255.255.255.0
access-list static_out_filter standard permit any
route-map static_out_filter permit 10
match ip address static_out_filter
sla monitor 10
type echo protocol ipIcmpEcho 38.107.x.x interface outside
num-packets 3
sla monitor schedule 10 life forever start-time now
service resetoutside
---------------------
10-22-2012 12:25 AM
Anand,
Thanks for the post. I dont see the question or the issue in your description, also, the Topology was not added.
Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide