04-05-2017 12:07 PM - edited 03-12-2019 02:10 AM
In an ASA redundant interface configuration, is there any way to designate which physical interface is the active of the redundant pair for the Active as-well-as the standby?
Thanks
Frank
Solved! Go to Solution.
04-05-2017 08:35 PM
You can designate which interface is active. Whatever designation you make will be synchronized across the Active and Standby appliances in the HA failover pair.
Cisco explains it here:
http://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/general/asa_91_general_config/interface_start.html#19964
... as follows:
Changing the Active Interface
By default, the active interface is the first interface listed in the configuration, if it is available. To view which interface is active, enter the following command:
ciscoasa# show interface redundantnumber detail | grep Member ciscoasa# show interface redundant1 detail | grep Member Members GigabitEthernet0/3(Active), GigabitEthernet0/2 To change the active interface, enter the following command:
ciscoasa# redundant-interface redundantnumber active-member physical_interface where the redundant number argument is the redundant interface ID, such as redundant1 .
The physical_interface is the member interface ID that you want to be active.
04-05-2017 08:35 PM
You can designate which interface is active. Whatever designation you make will be synchronized across the Active and Standby appliances in the HA failover pair.
Cisco explains it here:
http://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/general/asa_91_general_config/interface_start.html#19964
... as follows:
Changing the Active Interface
By default, the active interface is the first interface listed in the configuration, if it is available. To view which interface is active, enter the following command:
ciscoasa# show interface redundantnumber detail | grep Member ciscoasa# show interface redundant1 detail | grep Member Members GigabitEthernet0/3(Active), GigabitEthernet0/2 To change the active interface, enter the following command:
ciscoasa# redundant-interface redundantnumber active-member physical_interface where the redundant number argument is the redundant interface ID, such as redundant1 .
The physical_interface is the member interface ID that you want to be active.
04-06-2017 07:31 AM
Excellent and Thank you
Frank
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide