cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1152
Views
0
Helpful
1
Replies

ASA problem - I cannot nat from hub router to outside interface

BC83676
Level 1
Level 1

Hello,

 

I am having problems nating from DMVPN HUb router to outside interface.

 

Topology = (router -> outside switch -> ASA FW 9.x version)

 

I have been following the document https://www.cisco.com/c/dam/en/us/td/docs/solutions/CVD/Sep2017/CVD-IWANDeployment-SEP17.pdf however, i got stcuk on procedure 3 (Configure network address translation).

 

After configuration on asdm when trying to apply I have the following error:

 

[ok] object network dmz
object network dmz
[ok] host 192.168.1.1
[ERROR] nat stactic outside net-to-net
Address 172.168.1.1 overlaps with outside interface address.
ERROR: NAT Policy is not downloaded

 

Router can ping the Firewall, however it cannot ping internet (8.8.8.8).

 

Any 

 

1 Accepted Solution

Accepted Solutions

BC83676
Level 1
Level 1

After reviewing all the settings have concluded it was an ACL missing.

View solution in original post

1 Reply 1

BC83676
Level 1
Level 1

After reviewing all the settings have concluded it was an ACL missing.

Review Cisco Networking for a $25 gift card