04-10-2013 02:38 PM - edited 03-11-2019 06:26 PM
Hi All,
we are having an issue with ASA sip inspection. here is our topology:
CUCM-A --> ASA-A -- > ASA-B --> CUCM-B
phone from site A calls site B, call is connected and media is being passed. when phone in site A puts the call on hold, the call is dropped immediatly. I did packet capture from ASA-A egress interface, and it is sending its own public IP address in SDP contact when phone A puts the call on hold. is it supposed to be 0.0.0.0 when phone A puts the call on hold?
appreciate any suggestion
Alex
04-10-2013 03:25 PM
Hello,
As long as I know that behavior of setting the SDP contact as 0 has been deprecated,
Check the following RFC for more comments
http://tools.ietf.org/html/rfc5359#section-2.1
Regards,
Julio
Remember to rate all of the helpfull posts
04-11-2013 11:26 AM
Thanks for the link, but even I don't see "audio=inactive" in SDP header coming from ASA-A.
04-11-2013 03:35 PM
Hello,
Is there a way you could attach the debugs and captures to this discussion
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: