ASA to PIX Site to site tunnel is down

[enjama]

Hello All - We have a site-to-site vpn tunnel set up between an asa and a pix.  We applied the wrong config to ONE of them (possibly both?), and now the tunnel won't build.

I have attached the running configs for both. They seem complete - what are we missing?  The ASA has two tunnels configured, one is working, the other is not ( the one that goes to 216.24.130.4).

[Aditya Ganjoo · Accepted solution]

Hi,

Your configuration does not seem correct.

You have two tunnel configurations for the same peer.

crypto map transam 2 set peer 216.24.130.4

crypto map transam 4 set peer 216.24.130.4

Please remove one of the configurations and then test.

Regards,

Aditya

Please rate helpful posts and mark correct answers.