07-09-2012 01:25 PM - edited 02-21-2020 04:41 AM
Hi Everybody,
I was wandering if it possible the deploiment shown in the figure below.
The situation is:
Right now there is one ASA5505 that does Failover between the two ISPs using and SLA tracking.
I need add another ASA5505 in order to implement A/S failover for the Hardware but I'm not sure if the ISP failover is going to work witht the A/S deplyment.
Somebody could confirm if this scenario is valid??
Best Regards,
Jose
Solved! Go to Solution.
07-10-2012 01:43 AM
Yes, i don't see a reason why it wouldn't work. It will continue to work with SLA tracking as there is only 1 active IP Address that the ASA uses, and the same ip address follows the active firewall.
07-10-2012 01:43 AM
Yes, i don't see a reason why it wouldn't work. It will continue to work with SLA tracking as there is only 1 active IP Address that the ASA uses, and the same ip address follows the active firewall.
07-10-2012 06:24 AM
thanks Jennifer, One last question: Does the ASA5505 (Security Plus) support A/S High Availability??? Best Regards, Jose
07-10-2012 06:34 AM
No, A/S failover is not supported on ASA5505.
Here is the doc for your reference:
http://www.cisco.com/en/US/products/ps6120/prod_models_comparison.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide