cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1074
Views
5
Helpful
2
Replies

ASA5525-X FirePower - No On-Site VM Servers

Hello everyone, 

I've done numerous ASA NGFW installs with FirePower and I've used a FireSight VM server to perform the configurations for the URL filtering. 

I am working with a client who does NOT have any on-site servers, everything is hosted remotely through a VPN connection. 

I was wondering if anyone has any suggestions on how I can configure this. Thanks! 

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
Hall of Fame
Hall of Fame

As long as the FirePOWER module can reach the FireSIGHT Management server via https it should work fine.

Typically we would route out of the module via the physical ASA management interface and set a gateway as the ASA inside interface address.

If they have an internal router / L3 gateway, you can route via that as well.

View solution in original post

2 Replies 2

Marvin Rhoads
Hall of Fame
Hall of Fame

As long as the FirePOWER module can reach the FireSIGHT Management server via https it should work fine.

Typically we would route out of the module via the physical ASA management interface and set a gateway as the ASA inside interface address.

If they have an internal router / L3 gateway, you can route via that as well.

Thanks Marvin, I'll give it a shot. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: