Network Security

Engage with peers and experts on network security topics such as FTD, FMC, FDM, CDO and ASA.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

 Hi everyone, I have two networks one for LAN users other for WIFI users.Network 1 ASA1 users are connected and getting IP in subnet 10.0.0./24vlan 1 10.0.0.0/24 Network 2 AP----10.31.2.37/24----Switch--Layer2-------trunk vlan 2 and 3----------------...

mahesh18 by Level 6
  • 275 Views
  • 2 replies
  • 0 Helpful votes

Hi all, does anyone know how to crate a list of all firewalls with their interfaces and the IP addresses?Example:Firewall XXXX Inetrface XXXX 1 IP XXX                          interface YYYYY 2 IP YYYYFirewall AAAA interface AAAA IP AAAAA            ...

We have a new ASA 5516X and I realize the NAT commands are different on version 9.4(1) and version 8.2 which is our old ASA 5510.  I am unable to create the commands for the following: global (outside) 2 X.X.X.X (public IP address)nat (inside) 0 acce...

BCS121157 by Level 1
  • 2674 Views
  • 4 replies
  • 0 Helpful votes

Resolved! NAT hosts into ASA

Hi I have 2 internal hosts which are part of the same subnet as my inside interface and I have a single public IP. My internal hosts are:Host A - 10.10.10.1 (RDP)Host B - 10.10.10.2 (HTTPS) How can I configure NATS so that I can access one of the int...

Hi GuysI want to connect into my IPVPN using BGP so by just doing PE to CE BGP peering. The ISP has configured the PE end and I need to configure the CE end. It has simple config when using a router on the CE end, but how would I configure this using...

Hi every bodyI need your help . i receive this list from a supplyer. the thing is that, we are setting up secured vpn between 8 sites, and there is 1 site among the 8 will set as Master site, which in toure will be connected to another master siteple...

afayemf10 by Level 1
  • 1197 Views
  • 7 replies
  • 0 Helpful votes

Hi,We have a cisco IPS module in ASA which supports SDEE. I would like to know if we can get the logs for configuration changes, user account creations etc using SDEE. Splunk is used to get the SDEE events and we are receiving only the intrusions and...

Have a customer that has two VLANs (Layer3 on ASA for each VLAN).  I need to get AirPlay through the firewall.  The customer has Guest WiFi on one VLAN and the AV equipment (including Apple TVs) are on the second VLAN.  I found a doc with some TCP an...