Hello,
we replaced our PIX525 firewall with an ASA 5540 firewall, and now we see some strange behavior in ASDM.
ASDM does not display all the rules, but i see all all the rules in cli.
What can be the problem?
inside-asa# show ver
Cisco Adaptive Security Appliance Software Version 8.2(5)
Device Manager Version 6.4(5)
Solved! Go to Solution.
Hello Erik,
Do you think you can do an upgrade to 6.4(7) as this is the recommended version by CISCO when you are running 8.2(5).
Regards,
Julio
Hello Erick,
Are you talking just about the ACL rules?
Regards,
Yes, just about the ACL rules. We does not use NAT because this firewall is an internal firewall.
Hello,
I really need help.
Have somebody else find this problem?
In addition, I noticed that the rules under CLI is have different order than the rules in the ASDM.
Hello Erik,
Do you think you can do an upgrade to 6.4(7) as this is the recommended version by CISCO when you are running 8.2(5).
Regards,
Julio
Sure, i think we can manage that but i can only reply after one or two weeks ( change management ).
But i thought that our ASDM version is OK with this ASA version, see the link,
http://www.cisco.com/en/US/docs/security/asa/asa82/release/notes/asarn82.html#wp309157
Thank you for you help.
Thanks for the help, we updated the ASDM software version on a test ASA firewall and everything is OK.
6.4.5(206) is OK too.
Hello Erik,
Great to hear that everything is working now.
Have a wonderful day,
Julio