02-14-2012 03:31 PM - edited 03-11-2019 03:29 PM
Hi All
I am having an issue with the packet captured on the ASA, I am trying to download the PCAP file from the ASDM.
I am trying the following format:
https://security appliance-ip-address/admin/capture/capture_name[/pcap]
This was working but seemed to have stoped for some reason.
Regards MJ
02-14-2012 06:17 PM
Make sure you're sourcing from an address that has http access to the device (it worked before, just confirm again). Could also be that the file is too big (unlikely, but possible).
Lastly, you may want to just TFTP the config by using the following command
copy capture: tftp:
Then configure the following
Source capture name []?
Address or name of remote host []?
Destination filename []?
Good luck
02-14-2012 07:19 PM
Or you could transfer the file over https using ASDM's file management menu. Navigate to the file, select "View" (then possibly "save as" from your browser).
I find it easier to do the captures in ASDM which can then be setup to automatically open them in Wireshark.
02-15-2012 12:15 AM
Hi
Thanks for the answers, here is the error message I am seeing.
The XML page cannot be displayed
Cannot view XML input using style sheet. Please correct the error and then click the Refresh button, or try again later.
Thanks MJ
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide