05-21-2014 10:44 AM - edited 03-11-2019 09:13 PM
I am trying to setup a Backup ISP for an ASA5505. I have successfully configured the interfaces, routes and tracking. One interface is called outside and the other is called failover. When the cable is pulled from the outside interface, the failover route becomes active. However, no traffic is going from the inside interface through the failover interface. I can reach the failover interface via ASDM or putty. It seems like I may have a nat issue from inside to the failover interface. Any help would greatly be appreciated. Thanks.
Solved! Go to Solution.
05-21-2014 10:57 AM
The NAT looks OK.
Shouldn't the failover interface be security-level 0?
By default, same-security traffic is not permitted inter-interface.
05-21-2014 10:57 AM
The NAT looks OK.
Shouldn't the failover interface be security-level 0?
By default, same-security traffic is not permitted inter-interface.
05-21-2014 11:07 AM
That makes sense. I will set it to 0 and give it a try. Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide