Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup a Backup ISP for an ASA5505. I have successfully configured the interfaces, routes and tracking. One interface is called outside and the other is called failover. When the cable is pulled from the outside interface, the failover ...
We have two switches; a WS-C3550-48 and a WS-C3548-XL connected via fiber uplink ports. Both switches are on the same subnet 192.168.1.0 /24. I would like to change the subnet of the second switch, WS-C3548-XL, to be on 192.168.2.0 /24. Would it be p...
We have just merged with a company that uses Cisco SPA303 IP phones. These phones are configured to send voicemail to email. They use Exchange 2007, but do not use Unified Communications. I am trying to figure out where this is configured, but I cann...
Using Anyconnect 2.5 and ASA 5510. When a user connects to the VPN, the DNS settigs change from "Append Primary" suffixes to "Append these suffixes." (See below)The PublicDomain.com suffix is listed as the default domain in the Group Policy. The prob...
I am running out of IP addresses on 192.168.1.0 /24 and these switches are seperated by location (connected via Fiber). I need someone to point me in the right direction on how to setup a seperate subnet over two switches connected via uplink ports. ...
