Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I have a PIX506E that was resently reset and it has version PIX Version 7.1(2) .  It either uses some different commands or I am not using them correctly.PIX506E# show ip address insideSystem IP Address:Interface                Name                  ...

I have a Primary\Secondary LAN state firewall  pair.  The primary firewall is "Active", the secondary firewall is  "Standby Ready".  The running config has no "failover active" or "no  failover active" directives in place.  I want to manually fail ov...

cisco29111 by Level 1
  • 41432 Views
  • 1 replies
  • 0 Helpful votes

Hi FriendsBased on the show version output below, does this FW have 250 user license for AnyConnect? The reason I asked is because, 4 users could connect to the Cisco ASA FW concurrently but based on the show version output, it doesn't state 250 at a...

                  Hi Can someone tell me if this is possible and if so what commands do i need to configure on my ASA 5510 for it to work.I have two web server within my DMZ and i want to access the outside url of on on the web server from the other....

Hi All.I'm having a quirky problem with a PIX 501 and was wondering if anyone had any ideas.Recently I've pulled a PIX 501 out of a closet (having never been used) and configured it for a VPN with my PIX 506e at an offsite location. This offsite loca...

cwcadmin1 by Level 1
  • 691 Views
  • 2 replies
  • 0 Helpful votes

Hello everyoneWe have a new ASA 5505I setup the internal interface in vlan 1, setup outside interface to vlan 2 with security set to zero 0.we setup NAT rule to PAT dynamic and hide, confirmed I can ping the outside static IP address given by our ISP...

Good morning,I'm trying to dissect the ASA running config - to understand what we have running line per line, is there any documentation that details what each line is for like the DMZ, inside, outside and what's required to configure the ASA, what w...