Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Need to prepend traffic from a DMVPN peer so that it does not directly send traffic to this site, I tried applying route map with prepend, but it is not showing up in neighbor route statementThanks
Hi,
6816 card is configured for performance, need to remove it, will adding command: hw-module slot 2 oversubscription, cause any issue with active ports on the card or any other disruption as this is an operational switch
Thanks
Hello,
I have 2 MPLS routers from different carriers on remote site, iBGP between them is via core switch over ospf, they don't have a direct connection between them. I have following access list applied to both router's EBGP peers to carriers
!ip ...
Hello,
I am redistributing static routes in ospf stub area by using redistribute static command, static routes does not show up under "sh ip route ospf", they show as static & not redistributed in ospf under "sh ip route" , what need to be added to ...
Hi,
I am setting up 2 switches with OSPF & HSRP, using /32 for each interface under OSPF, will standby interface IP used on both switches or physical interface IP under OSPF ?
thanks
hasrat
Hi,
This is what I thought, but these are being re advertised & I have to shut iBGP peer, that's why wondering if BGP routing table treats iBGP routes learnt via OSPF differently than if there is a direct connection between routers & iBGP routes ar...
