Guys,I want to divert the traffic originating from E3(Server Farm) to E2 using some kind of route-map/PBR but found out that ASA doesnt support this. Is there any other way to accomplish this? Thanks,Chad
Guys,I want to divert the traffic originating from E3(Server Farm) to E2 using some kind of route-map/PBR but found out that ASA doesnt support this. Is there any other way to accomplish this? Thanks,Chad
HiI have a Cisco ASA 5520 and a Cisco 3825 router in my network. I want to log every connection made to these devices. There are a few users who have different levels of access to these n/w devices. I want to log all these users and what they actuall...
NAC Manager stop responding HTTPS after activation of HAI currently installing NAC in a lab, and as soon as I reboot the Manager after configuring the HA the server stop responding to HTTPS and I received Service Temporarily Unavailable. After reboot...
i have a problem with my pix 525.it starts to boot and then hangs at that spot forever.m not sure if its an ios issue or notCISCO SYSTEMS PIX FIREWALLEmbedded BIOS Version 4.3.207 01/02/02 16:12:22.73Compiled by morlee256 MB RAMPCI Device Table.Bus ...
Hi all!I've an ASA 5520 having one interface (GUEST) with security level 5.Now, if i add a rule to permit all traffic to outside network (like permit any any), i see that they can also reach the INSIDE interface (security level 100).I have to deny th...
Hello I'm configuring 2 ASA for failover. The first configuration of the primary unit is done ! For the second unit, do we have to configure the ip address of the interfaces and the other configuration or just Failover command ?Do we have to do 'no...
Hi all,I have a Cisco ASA 5510 with BASIC Configurations but I can't access internet from the inside interface.I can ping internet servers from Outside interface but can't ping or browse from the inside.Below is the basic configurationPlease Urgent h...
Hello,I just created a new and simple signature. signature 60002 for failed telnet. My setup is Promiscous mode . signature 60002engine string-tcpservice-ports 23direction from-serviceregex-string % Bad passwordsalert-frequency fire-allDid I miss so...
Hello All,We have ASA5510 as a NAT server, and it works correctly on NAT for inside computers.But for some concern, we want these inside hosts connecting to some outside network hosts with a different route.i.e.:inside_hosts ---------> Internet ...
So far, all I can find on the ASA is an Application Inspection Match Criteria for the HTTP CONNECT request that carries you into the world of HTTPS (SSL). Vendors who can inspect SSL generally brag about it and have to devote at least one chapter in...
Hi All , I m facing issue with two active FTP session from outside to inside , server is placed inside to firewall .While single FTP session is working fine with same config on f/w .here are the logs which is captured the during the issue -%ASA...
I seem to be having a problem wrapping my head around what is going on or what to do.What I have is two subinterfaces:interface FastEthernet0/1.1 encapsulation dot1Q 10 ip address 10.10.2.254 255.255.255.0 ip access-group vlan10_in in ip nat inside i...
Hello,1) I want to upgrade from K8 to K9,i hope there is no image as such K9 but the licence will do the job for K8 to K9 ( i.e 3DES/AES) Generally K9 means 3DES/AES enabled????? please correct me if i m wrong.???2) The show version below is from ...
Below is the confignamesname 172.16.128.0 FW_SEGMENTname 192.200.229.0 HRSDNETname 172.16.32.0 WBFW_SEGMENTname 172.16.96.0 NSFW_SEGMENTname 172.16.64.0 VIPFW_SEGMENTname 172.16.84.0 ATFW_SEGMENTname 172.16.128.51 YREDSname 192.168.251.0 VPNname 192....
I have a Firewall, with 3 interfaces, One inside and 2 outside. I need to hide the 2rd outside Network from the Inside Network, and need to know how to write the NAT for this.for a better explaination. The Inside interface is 10.152.0.1/16, Outs...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 11-14-2026 01:46 AM | ||
| 11-12-2026 11:33 AM | ||
| 11-12-2026 11:09 AM | ||
| 11-12-2026 12:41 AM | ||
| 11-06-2026 12:20 AM |
| User | Count |
|---|---|
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 |