Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

I'm trying to set up my ASA (running v8.3(1)) to allow traffic from my web server on my DMZ to access one of my internal servers (server B) over port 80. I have configured the static translation to translate from my DMZ ip address scheme to the IP ad...

snowmizer by Level 1
  • 1342 Views
  • 10 replies
  • 0 Helpful votes

Hello,I have been tasked to implement for my company a security system based on firewall+IDS/IPS.In order to limit the number of devices providing at the same time firewall system redundancy, I am considering to acquire two Cisco ASA 5540 (or 5520) I...

We have couple routers taht we can get connection information ( like emby. max etc )....similiar to this:router#show ip inspect statisticsPacket inspection statistics [process switch:fast switch]tcp packets: [528:22519]udp packets: [318:0]Interfaces ...

jbeltrame by Level 1
  • 14486 Views
  • 6 replies
  • 0 Helpful votes

Hello all,I’m trying to figure out the best way to connect two ASA 5510’s together and have run into a bit of a snag.  I have two ASA 5510's, one has a CSC-SSM and will act as a Firewall, Antivirus and VPN (I'll call it the CSCASA) and the other has ...

hnbbank01 by Level 1
  • 3482 Views
  • 19 replies
  • 0 Helpful votes

Hello all,I am trying to find out if possible to do the following:I have a server in the DMZ: 172.17.1.100 /24 and server in the inside 172.20.1.200 /24 both will have the same nat ipaddress outside: 1.1.1.200 this can be done using policy nat. ( I t...

ttran by Level 1
  • 1118 Views
  • 2 replies
  • 0 Helpful votes

I'm using the following procedure list to try to recover the password (/blank the password) on a PIX 515 http://www.cisco.com/en/US/products/...8009478b.shtml I have the appropriate binary file (np63.bin) and have a computer  connected to the netwo...

Hi All,Is there way to display the a standard TCP/UDP  port number(s) defined in a ASA/PIX?for example, when creating an object-groupFWNAME(config-service)# service-object tcp ?dual-service-object-group mode commands/options:  <0-65535>        Enter ...

merryllem by Level 1
  • 1286 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card