Network Security

Hi,I have set up my 877w with the following config, I wanted to block incoming access to the ATM0.1 interface so created the "OUTSIDEIN" access list.I also created the INSPECTOUT list for outgoing packet inspection (which I believed would bypass the ...

Hello,I have recently been monitoring our IPS sensors and see that one is usually always in a "critical" 99% load very frequently. Was there a recent update or something I should be aware of... Additionally, Our IPS alerts are up and down all the tim...

ROMMON Variable Settings: ADDRESS=172.16.X.X ---MANAGEMNET IP SERVER=172.16.x.x----TFTP SERVER IP GATEWAY=172.16.X.X -------MANAGEMNET IP PORT=Management0/0 VLAN=untagged IMAGE=IPS-K9-6.1-1-E1.pkg CONFIG= LINKTIMEOUT=20 PKTTIMEOUT=4 RETRY=20tftp IPS-...

We have a requirement to purchase the Cisco CSS content switch and take advantage of the "sticky" function.Where would one put a CSS on the network, is it best to go on the DMZ or one of the internal vlans?

I have an 877W that I'm trying to configure IPS on, but I'm not seeing any traffic to it. It shows that it's dropping packets but it's not logging anything.This is strictly a test environment, and my question is what do I need to put on the inside in...

We have a office in which pcs are connected to hp switch to ASA and cable modem to cmts and we have intermittent connections there and to regain the connection back ,, at few occasions they tried resetting modem as there was no light and as it did no...

have an ips 4240 running software version 6.0(2).I used admin,operator,viewer and service accounts to login but nothing works.It tells me incorrect login.I set confreg 0*7 at rommon then boot the system.It allows me to change the password but as soon...

Hi Guys, How are you?I need to configure ASA 5505 as central point with static IP. I already saw "PIX/ASA 7.x PIX-to-PIX Dynamic-to-Static IPsec with NAT and VPN Client Configuration Example" guide.But the problem is when I use "isakmp key password a...

We have a number of static PAT as well as policy NAT pointing services from servers and loadbalancers to the outside world on specific ports. In this case, our Postfix Mail server is accepting inbound connections fine, and sending out fine - however....

Hello,I would like to enable IPS on my Cisco Router 1812. If I configure basic IPS settings (category all; retired true; category ios_ips basic; retired false;) and then use the latest signature pkg pack during copying them into idconf, I get followi...

Hi All,I am receiving a number of errors on my Cisco ASA 5510 device that reads: 106016: Deny IP spoof from (127.0.0.1) to x.x.x.x on Interface Insidex.x.x.x is some random IP Address. There are a number of IP Addresses that are reported. Any ideas?