- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-31-2022 11:04 AM
Does a specific rule need to be created on the ASA to block IPv6 traffic, or will the default block deny the traffic if no specific rule is in place?
TIA
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-31-2022 11:09 AM
@MLighthill by default the ASA will have an implicit deny at the end, so unless you permit the traffic it will be denied.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-31-2022 11:09 AM
@MLighthill by default the ASA will have an implicit deny at the end, so unless you permit the traffic it will be denied.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-31-2022 11:12 AM
Thank you sir!
That was my thought, but I was wanting to make sure.
