Hello,Now ive realized our FTD cant access the cisco license server and therefore nor any module updates neither. Cant remember if mine or my bosses changes did break it.Ive looked through the policies and from my view the setup is ok, i cant find wh...
Forum Posts
Hi All, we just got some issues and reinstall FMC and restore backup and add 2 x 2130 FTDs with HA, but we can not change device interface duplex and speed configs. Error is attached and please advise. regards
Hi Tech People. I have FMC with two FTD device. i want to allow the external traffic from FMC Management interface towards the internet for Cisco cloud and cisco smart account for license. My management vlan is created on the Layer2/3 switch and FMC ...
Resolved! Ise guest portal hotspot error
Hello,We are runnning cisco 2 ise nodes as pri/sec with ver 3.1.0.518 patch 1when i am connecting to a guest portal the client gets Hotspot error server cannot be reached. However, the clients and ISE guest network is in differet subnets able to reac...
hi,i'll apply a security context license on a active-standby HA pair firepower 2100 running ASA.L-FPR2100-ASA=L-FPR2K-ASASC-10=i also got an on-prem smart license server.can someone advise if below config is correct? do i configure smart license unde...
Resolved! FMC HA Pair reboot after update
I have 2 new Firepower devices in a HA Pair scenario, and I want to install an update on them through my FMC GUI. It states that reboots of the firewalls are necessary to complete the update. I have to assume that the reboots will not occur simulta...
Hello, Attempting configure AWS Virtual firepowers. Is there a way to add a complete configuration into Cloudformation Instance User Data like there is with ASAs? I've only seen examples that you can add default passwords like this: UserData: Fn::B...
My ftd can't connect to fmc because of routing reasons, now I need to add a static route and make the configuration priority higher than ospf
Hi Community,I am trying to deploy new lab for FTD(v6.2.0)/FMC(v6.2.2) with 90 days evolution. But I got the below error. Tried to remove and recreate the lab, but every time getting the same problem as per the screen shot.Please support to resolve.
Hi,Does Cisco ASA or FirePower support GRE tunnel?
Hello All,ISE v2.7Currently, we are using a Certificate on ISE that is signed by our internal Windows CA server. This cert is used for "Admin, EAP Authentication, RADIUS DTLS, Portal".We also use a certificate from Digicert for our Guest Portal.The i...
We're having a problem with PTR records not being scavenged by our DNS server for users connecting through AnyConnect. We're planning on moving away from the local pool to a DHCP server, but I'm not find much info. Does the following configuration lo...
Does anybody know if Cisco ISE(version 2.4) is affected by Apache Struts2 remote execution vulnerability（Struts-045、Struts-046）?Thanks a lot!，
CVE-2021-31805 - Has a Cisco Product Impact list been announced? It describes Affected system: Apache Struts version 2.0.0 - 2.5.29.How do I check the current apache version running on Cisco ISE? Thanks.
Since one node as being Active and other node as being standby, Active/Active failover is not being used here, if so timing should be same on both firewalls. Pls clarify?
