Changing Interface Bandwidth on ASA

[Garry S]

Hello,

I have an ASA 5520 running 8.2 (I know) which is connected to two managed-CPE routers. One of these routers has a 20Mb WAN connection, while the other has a 5Mb WAN connection.

I'm running EIGRP on the ASA and, to influence path selection, would like to set the interface bandwidths to 20Mb and 5Mb respectively. On an IOS device this would, of course, be no problem. I cannot find a bandwidth command on the ASA. Am I missing something or should I just use another method?

Thanks.

[Ji-Won Park]

I went through the 5500 8.2 config guide and couldn't find a way to customize BW in interface level - you can do it global. You will have to use delay if you want to apply on the interface:

http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/route_eigrp.html#wp1109190

Hope it helps.

g1