09-11-2007 08:51 PM - edited 03-10-2019 03:47 AM
How can i change the sensors time manually on my AIP-SSM-10 module installed in the ASA 5520 device .. ??
i tried the clock set command but apparently its not supported on AIP-SSM-10 module.
the ASA has the correnct time but the IPS does not...
any ideas ??
thanks..
zaid
09-17-2007 12:44 PM
AIP SSM can automatically synchronize its clock with the clock in the ASA in which it is installed. This is the default. The UTC time is synchronized between ASA and AIP SSM. The time zone and summertime settings are not synchronized between ASA and AIP SSM. You have to configure the time zone on the SSM because it is the UTC time that it gets from the ASA.
09-20-2007 01:27 AM
You can find the complete configuration guide for the AIP-SSM-10 in the URL posted below. The configuration of the time-settings is explained in the following chapter: 'Initial Tasks > Configuring Time'.
Please rate if the post is usefull!
Regards,
Michael
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide