Cisco 1702 AP in standalone mode is not being accessed

[diwakar410]

I have cisco 1702 AP and i changed its mode from default controller mode to standalone mode. Kept the IP address of the AP 192.168.1.100 from puttty  by using the command: 

interface bvi 1

Ip address 192.168.1.100

When connected to the network, i can ping 192.168.1.100 but can't get the access of GUI from browsers. I get the login page too and nothing appears after that.

The problem could be that when i keep the ip in the interface bvi 1 the IP is set in the NVRAM. Is it creating the problem?

Please help.

[Leo Laohoo]

When connected to the network, i can ping 192.168.1.100 but can't get the access of GUI from browsers.

Post the complete output to the command "dir".

[diwakar410]

Hi there,

I changed the network to 192.168.123.253 and the issue is same. Here is the putty log.

ap#show ip int br
Interface IP-Address OK? Method Status Protocol
BVI1 192.168.123.253 YES NVRAM up up
Dot11Radio0 unassigned YES NVRAM administratively down down
Dot11Radio1 unassigned YES NVRAM administratively down down
GigabitEthernet0 unassigned YES NVRAM up up
GigabitEthernet1 unassigned YES NVRAM up down

ap#show running-config
Building configuration...

Current configuration : 2043 bytes
!
version 15.3
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname ap
!
!
logging rate-limit console 9
enable secret 5 $1$6vIV$wPH3jIX2zla26JEo3QDtQ.
!
no aaa new-model
no ip source-route
no ip cef
!
!
!
!
dot11 syslog
--More-- !
--More-- dot11 ssid Nexus wifi
--More-- authentication open
--More-- authentication key-management wpa version 2
--More-- wpa-psk ascii 7 1419171319177B79777C66
--More-- !
--More-- dot11 ssid Nexuswifi
--More-- authentication open
--More-- !
--More-- dot11 ssid nexuswifi
--More-- authentication open
--More-- !
--More-- !
--More-- !
--More-- no ipv6 cef
--More-- !
--More-- !
--More-- username Cisco password 7 05280F1C2243
--More-- !
--More-- !
--More-- bridge irb
--More-- !
--More-- !
--More-- !
--More-- interface Dot11Radio0
--More-- no ip address
--More-- shutdown
--More-- !
--More-- encryption mode ciphers aes-ccm
--More-- !
--More-- ssid Nexus wifi
--More-- !
--More-- ssid Nexuswifi
--More-- !
--More-- antenna gain 0
--More-- station-role root
--More-- bridge-group 1
--More-- bridge-group 1 subscriber-loop-control
--More-- bridge-group 1 spanning-disabled
--More-- bridge-group 1 block-unknown-source
--More-- no bridge-group 1 source-learning
--More-- no bridge-group 1 unicast-flooding
--More-- !
--More-- interface Dot11Radio1
--More-- no ip address
--More-- shutdown
--More-- !
--More-- ssid nexuswifi
--More-- !
--More-- antenna gain 0
--More-- peakdetect
--More-- no dfs band block
--More-- channel dfs
--More-- station-role root
--More-- bridge-group 1
--More-- bridge-group 1 subscriber-loop-control
--More-- bridge-group 1 spanning-disabled
--More-- bridge-group 1 block-unknown-source
--More-- no bridge-group 1 source-learning
--More-- no bridge-group 1 unicast-flooding
--More-- !
--More-- interface GigabitEthernet0
--More-- no ip address
--More-- duplex auto
--More-- speed auto
--More-- bridge-group 1
--More-- bridge-group 1 spanning-disabled
--More-- no bridge-group 1 source-learning
--More-- !
--More-- interface GigabitEthernet1
--More-- no ip address
--More-- duplex auto
--More-- speed auto
--More-- bridge-group 1
--More-- bridge-group 1 spanning-disabled
--More-- no bridge-group 1 source-learning
--More-- !
--More-- interface BVI1
--More-- mac-address e00e.da28.e7dc
--More-- ip address 192.168.123.253 255.255.255.0
--More-- ipv6 address dhcp
--More-- ipv6 address autoconfig
--More-- ipv6 enable
--More-- !
--More-- ip default-gateway 192.168.123.254
--More-- ip forward-protocol nd
--More-- ip http server
--More-- no ip http secure-server
--More-- ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
--More-- !
--More-- !
--More-- bridge 1 route ip
--More-- !
--More-- !
--More-- !
--More-- line con 0