Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Today i was trying to configure port forwarding in one of my client's office. They wanted me to forward ports like 5000 and 6000. I was given the GUI access of the cisco router 2900 series. I could not see any options for NAT or ACL there. I doubt we...
We have cisco WLC 2500 series and 5 APs 1700 series working on controller mode.I have configured the controller like i always used to do but this time the APs were unable to join the controller.This is what i did:controller IP address:192.168.1.250/2...
We have 5 APs currently working on regulatory domain C. We are adding 5 more APs and a WLC which has come in another regulatory domain as per my boss, he says it is H.
Will there be issues operating in 2 different domains?
What can i do for making e...
We recently purchased 2 Cisco SAN switch. Configuration portion is remaining in client's side. I haven't used it yet. Need ideas for fresh installment.
They already have 2 SAN storage, 4 physical servers and they want SAN on HA.
We have licence for 1...
I have a public IP of 201.202.203.204.
And then, i have pool IP of 205.206.207.208 which is routable to 201.202.203.204.
I have a service running on my server which opens locally on port 3456. ie, i get the access of server from inside network using ...
Actually, the problem was with my date and time configuration in cisco wlc. Everytime the WLC was shut down and again powered on, the date and time would set to default 2000 Jan 1. I am looking to work with the NTP server configuration in the wlc.
Hi there,
I have been connecting the AP to the POE port only. I have tried using the above commands too.
Yesterday, AP was able to join the controller and later i assigned static address to the APs, then the connection was lost.
Now, i am doubting th...
Thank you Rasika,
We are deploying in Nepal. As there is no option of Nepal there so what do i do?
So as per what i read, there is no way to change regulatory domains in AP, i will have WLC then will the new APs and the one ones that i already have,...
Christian,
Noted. Thanks a lot.
This command doesn't need any any
nat (private,public) source static obj-192.168.10.100 interface destination static any any service SOURCE-TCP-3389 SOURCE-TCP-2234
If we use any any then there will be this error:
ERR...
