cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1291
Views
0
Helpful
1
Replies

Cisco 2901 Router, Memory allocation failed, No internet connection

softimpera
Level 1
Level 1

Hello,

I am into a frustrating situation about a router Cisco 2901 (Firewall + IPS installed) and at every few days (3  -4 days) I get no internet connection . After I restart the router , the internet connection works. 

I have a small datacenter :  2 web servers Dell that host : DNS, Web, Email.

I have submited a case and the enginner told me that :  "These errors are popped out when the controller is bad and according to some previous Service Request as raised with Cisco, an RMA has normally resolved the issue".

.......................................................

MSI 192, name: wic_mbrd_hdlc_error, hdlr 0x3069BCA0, cnt 1, ctx 0x0, slot 0, IO_Controller, ERR, number 0

MSI 193, name: wic_mbrd_hdlc_error, hdlr 0x3069BCA0, cnt 0, ctx 0x1, slot 0, IO_Controller, ERR, number 1

.......................................................

So they replaced the router with a new one . I have installed and configured the new router . I''m not a cisco specialist, I used Cisco configuration professional.

After 3 days after the new router installation I get again : "No internet connection"  for ~30 minutes . After that I reset the router and then the internet connection works. The network was working.

This time I can access it I I get the logs :

082401: *Sep  6 03:56:52.008 UTC: %SYS-2-MALLOCFAIL: Memory allocation of 65536 bytes failed from 0x32C5B100, alignment 32

Pool: Processor  Free: 3230580  Cause: Memory fragmentation

Alternate Pool: None  Free: 0  Cause: No Alternate pool

-Process= "Chunk Manager", ipl= 4, pid= 1

-Traceback= 32C41914z 32C4C608z 32C387C8z 32C389D0z 32C2E550z 32C2E534z

082402: *Sep  6 03:56:52.012 UTC: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for Firewall State . No memory available -Process= "Chunk Manager", ipl= 4, pid= 1

-Traceback= 32C2E550z 32C2E534z

082403: *Sep  6 03:57:02.048 UTC: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ipnat entry. No memory available -Process= "Chunk Manager", ipl= 4, pid= 1

-Traceback= 32C2E550z 32C2E534z

082404: *Sep  6 03:57:02.508 UTC: %LICENSE-2-VLS_ERROR: 'VLSnotifyBirthAndExpiryEvents' failed with an error - rc = 25 - 'Error[25]: Could not understand the message received from license server on host "no-net".

--More--                           Client-server version mismatch?

'

-Traceback= 32C2E550z 32C2E534z

082406: *Sep  6 03:57:20.464 UTC: %COMMON_FIB-3-NOMEM: Memory allocation failure for path list in Common CEF [0x31B2CB58] (fatal) (0 subsequent failures).

082446: *Sep  6 04:12:28.528 UTC: %SYS-2-MALLOCFAIL: Memory allocation of 65536 bytes failed from 0x32C5B100, alignment 32

Pool: Processor  Free: 3277308  Cause: Memory fragmentation

Alternate Pool: None  Free: 0  Cause: No Alternate pool

-Process= "Chunk Manager", ipl= 4, pid= 1

-Traceback= 32C41914z 32C4C608z 32C387C8z 32C389D0z 32C2E550z 32C2E534z

082447: *Sep  6 04:12:28.528 UTC: %SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for IPS DP DYNAMIC . No memory available -Process= "Chunk Manager", ipl= 4, pid= 1

-Traceback= 32C2E550z 32C2E534z

082451: *Sep  6 04:13:33.872 UTC: %SYS-2-MALLOCFAIL: Memory allocation of 65536 bytes failed from 0x32C5C898, alignment 16

Pool: Processor  Free: 3287156  Cause: Memory fragmentation

Alternate Pool: None  Free: 0  Cause: No Alternate pool

-Process= "IP ARP Adjacency", ipl= 3, pid= 119

-Traceback= 32C41914z 32C4DDA0z 31B83C8Cz 31B85A64z 31B860B8z 31B7EF44z 31B2CF40z 31AEB994z 31B30B24z 31B30C74z 31AE05B8z 31AE06FCz 31BE9024z 3013EEB4z 3013F218z 3013F370z

--More--                           082452: *Sep  6 04:13:33.872 UTC: %COMMON_FIB-3-NOMEM: Memory allocation failure for validating prefix in IPv4 CEF [0x31ADD990] (fatal) (0 subsequent failures).

082453: *Sep  6 04:13:33.872 UTC: %COMMON_FIB-4-DISABLING: IPv4 CEF is being disabled due to a fatal error.

I contact again suport case but I received an general answer that tells me that "this might happen due to a normal or abnormal event............".

Can somebody help me ?

If the memory was full , why the router don't try a release / renew command ? Is the a command that can tell the router : whenever the memory is full to release / renew it ?

I hae attached the router configuration .

1 Reply 1

softimpera
Level 1
Level 1

I saw on forums that some workaround is to

- replace ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1 with IP route 0.0.0.0 0.0.0.0 DHCP .

- or replace with ip route 0.0.0.0 0.0.0.0 x.x.x.x !next hop IP

Who is in my case next hop ip ? The ip from WAN (GigabitEthernet0/1) ?

----------------

interface GigabitEthernet0/0

description $ETH-LAN$$FW_INSIDE$

ip address 192.168.1.1 255.255.255.0

no ip redirects

no ip unreachables

no ip proxy-arp

ip nat inside

ip virtual-reassembly in

zone-member security in-zone

duplex auto

speed auto

no cdp enable

no mop enabled

!

interface GigabitEthernet0/1

description $ETH-WAN$$FW_OUTSIDE$

ip address 88.x.x.157 255.255.255.128

  no ip redirects

no ip unreachables

no ip proxy-arp

ip verify unicast reverse-path

ip nat outside

ip ips sdm_ips_rule in

ip virtual-reassembly in

zone-member security out-zone

duplex auto

speed auto

no cdp enable

no mop enabled

!

ip forward-protocol nd

!

ip http server

ip http access-class 2

ip http authentication local

ip http secure-server

!

ip nat inside source list 1 interface GigabitEthernet0/1 overload

ip nat inside source static 192.168.1.88 34.x.x.178

ip nat inside source static 192.168.1.89 34.x.x.179

ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1

!

-----------------

How can I do this ?

Review Cisco Networking for a $25 gift card