06-28-2011 05:50 AM - edited 03-11-2019 01:52 PM
This morging (without changing anything recently in the ASA) the Cisco ASA wasn't working anymore.
When I connect with the ASA thrue the console, It's booting, but when loading the ASA Images, it hangs.
This is what happens during boot:
CISCO SYSTEMS
Embedded BIOS Version 1.0(12)13 08/28/08 15:50:37.45
Low Memory: 632 KB
High Memory: 507 MB
PCI Device Table.
Bus Dev Func VendID DevID Class Irq
00 01 00 1022 2080 Host Bridge
00 01 02 1022 2082 Chipset En/Decrypt 11
00 0C 00 1148 4320 Ethernet 11
00 0F 00 1022 2090 ISA Bridge
00 0F 02 1022 2092 IDE Controller
00 0F 03 1022 2093 Audio 10
00 0F 04 1022 2094 Serial Bus 9
00 0F 05 1022 2095 Serial Bus 9
Evaluating BIOS Options ...
Launch BIOS Extension to setup ROMMON
Cisco Systems ROMMON Version (1.0(12)13) #0: Thu Aug 28 15:55:27 PDT 2008
Platform ASA5505
Use BREAK or ESC to interrupt boot.
Use SPACE to begin boot immediately.
Launching BootLoader...
Boot configuration file contains 1 entry.
Loading disk0:/asa823-k8.bin... Booting...
I allready tried to restore (another) image thrue rommon with like bellow:
Enter the following commands in the ASA (the first part of these commands must be in caps)
rommon #1> ADDRESS=192.168.20.10
rommon #2> SERVER=192.168.20.1
rommon #3> GATEWAY=192.168.20.1
rommon #4> IMAGE=asa821-k8.bin
rommon #5> PORT=Ethernet0/0
Next, execute the command to transfer the image from the TFTP server to the ASA
rommon #6> tftp
Is my ASA broken ?
Thanks for the help
06-28-2011 07:59 AM
When you boot from rommon via a tftp server, the image is not written to flash. So even if you had a flash problem, it should still be able to boot from rommon. You may have another issue with the ASA hardware, but usually if there is a memory/cpu/mainboard problem then the ASA won't load rommon either.
When you attempted to boot from rommon, did your tftp server software indicate that the file was sent? Did it look like the ASA was able to communicate with the server at all? Make sure that any local firewall software is disabled on the tftp server. I would also try another port on the ASA just to be certain.
Thanks,
Brendan
06-29-2011 12:52 AM
The image was transferred succesfull then Rommon seas loading tftp image and again it hangs.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide