Hello everybody,
this is the configuration sample that Tunnelbroker gives to IOS router (not ASA )
configure terminal
interface Tunnel0
description Hurricane Electric IPv6 Tunnel Broker
no ip address
ipv6 enable
ipv6 address xx:xx:xx:xx:::2/64
tunnel source MY.WAN.IP..248
tunnel destination TUNNEL.BROERKIP.104.74
tunnel mode ipv6ip
ipv6 route ::/0 Tunnel0
end
The questions is how to put that into Cisco ASA 5505 with 8.2(1) OS version.
If anyone has be done this one, a good sample will be really appreciated.
Have a nice day/night.
Jos P.