Cisco ASA 5516-X Configuration

[VCsupport17]

Hello community,

I factory reset the Cisco ASA 5516-x firewall and after booting up the interfaces goes down.

I can console the firewall but what is the command to assign IP address on the interfaces and make goes to up?

Thank you.

[santosh_barwa]

How to do factory default or reset ASA5516 -X ??

It's a new firewall. And I had just just for practice I applied /created following commands.

Note: I did't apply any license key in it and configured following commands. And unfortunately I got locked. Notable to access cli as well as through GUI. Any way to set factory default??? If any help much appreciated

hostname ASA1

crypto key generate RSA label cciekey modulus 1024

 crypto ca trustpoint ccietrust

enrollment self

subject-name CN=ASA1 Of=cisco.com

Then I powered off the device. Thought whatever I have I configured it should erase.

[Marvin Rhoads]

@santosh_barwa,

You've jumped on an old thread about an issue with FTD.

Please start a new discussion for your non-FTD ASA issue.

[waheed.sami@mercurymena.COM]

I have setup Cisco ASA 5516 with 2 WAN ports for Internet failover. It was working fine till my both WAN ports are on DHCP and I have added static route for failover but since I have changed my WAN1 from DHCP to static IP I am having issue that all my traffic is going out from WAN2 instead of WAN1.

In Static route WAN1 Matrices Distance is 1 and setup as tracked and WAN2 distance is 10.

In monitoring WAN2 is showing as default route instead of WAN1. Please help me to resolve this. Thanks

Waheed Sami.

[Marvin Rhoads]

Can you share the sections of your configuration with the relevant routing and ip sla bits?

[waheed.sami@mercurymena.COM]

Please find attached configuration backup file. If can be helpful.

[Marvin Rhoads]

Please check your posting - no attachment is included yet.

[milton robertson]

How did you perform the factory reset process? I have been trying for the past hour and still - no success.