Cisco ASA 5516-x LACP + Failover + Switch Stack

[Alex Ribas]

Hi 

I configured

2 ASA 5516x

One in One swich 01 and Switch 02

Both in Stack

Check the jpg if possible

I missing something?

Thank you

Alex

[Rob Ingram · Accepted solution]

@Alex Ribas 

Are you using 1 etherchannel on the switch stack?

If you use the ASA in an Active/Standby failover deployment, then you need to create separate EtherChannels on the switches in the VSS/vPC (or stack), one for each ASA.

See figure 2 in this link - https://www.cisco.com/c/en/us/td/docs/security/asa/asa914/configuration/general/asa-914-general-config/interface-echannel.html