Hi,
we have bought the cisco part ASA5510-SEC-BUN-K9. According to the description, it has 2Ge and 3 FE ports but its showing me 5FE ports and doesn't have any GE port. How could i have 2 GE on this platform? is any special configuration/licence needs to be implemented.
Here is a show version
Result of the command: "sh ver"
Cisco Adaptive Security Appliance Software Version 8.0(4)
Device Manager Version 6.1(3)
Compiled on Thu 07-Aug-08 20:53 by builders
System image file is "disk0:/asa804-k8.bin"
Config file at boot was "startup-config"
Firewall up 331 days 20 hours
Hardware: ASA5510, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CN1000-MC-BOOT-2.00
SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.03
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.05
0: Ext: Ethernet0/0 : address is 001f.9f3c.71a8, irq 9
1: Ext: Ethernet0/1 : address is 001f.9f3c.71a9, irq 9
2: Ext: Ethernet0/2 : address is 001f.9fe3c.71aa, irq 9
3: Ext: Ethernet0/3 : address is 001f.9f3c.71ab, irq 9
4: Ext: Management0/0 : address is 001f.9f3c.71a7, irq 11
5: Int: Not used : irq 11
6: Int: Not used : irq 5
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 100
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 2
GTP/GPRS : Disabled
VPN Peers : 250
WebVPN Peers : 2
AnyConnect for Mobile : Disabled
AnyConnect for Linksys phone : Disabled
Advanced Endpoint Assessment : Disabled
UC Proxy Sessions : 2
This platform has an ASA 5510 Security Plus license.
Serial Number: **********
Running Activation Key: ******************************** Configuration register is 0x1
