Network Security

HelloI have an ASA with to contexts which share two interfaces (see attached graphic). Both contexts run on the same 5540I want to ssh Context B firewall from the Intranet, but it doesn't work.IP Routers are ok.I have configured access-lists on Conte...

Folks,trying to set up security context for one of our remote clients. they have an ASA 5540 and want to use it for seperating their own & their subsidaries traffic flow. Would each of these contexts have their own seperate interface details? Will th...

Hello, I have a DSL line with 3MB symmetrical upload and download. How can I guarantee 600 Kbps for a video stream that we emit? At the same time, I want this 600 Kbps available to the other traffic, when no broadcast video. Is it possible?What is th...

Hi Netpros,I am migrating from ASA5550 (running 7.2(4)33) to 5580-20 and was intending to use the same version. A second phase of the project will include image upgrade. By looking at the image available for download from Cisco for the ASA5580 it onl...

Hi Guys,I'm new to the ASA and I'm currently working with a 5510 (7.0.6). I'm trying to allow users from the "inside" interface access to a specific host (HOSTA) on a specific port (PORTA) via the "outside" interface. It is not working, and I am not ...

Hello,I upgraded from 4.5.1 to 4.7.1. I am having trouble with the communication between the CAS and the CAMHere is an outline of the issue1.       After Authentication, DHCP, ACS ok, WALL !!!2.       Nac Online Users = 03.       Ping the CAM HA serv...

I am trying to setup a second vpngroup on a pix 6.2 (I knowit is old but can't upgrade it yet) and am having a problem. I can connect to the new vpngroup and it works when there is not split tunnel configured butwhen I add the split tunnel command it...

Is it possible to have Multiple Internet Gateways on a ASA5510??  I would like to route some traffic out on one outside interface and the rest out the other.  As of now, ISP1 is the default gatway.

Hi friends..What are the steps to upgrade ASA 5510 to Security Appliance 7.2(1) with ASDM 5.2.1?Thanks a lot!

Hi all,I try to analyze a complex PIX config and would like to analyze the NAT usage. There are ALL variations of NATing in it, therefore I get static, dynamic, nat exemption etc.I can see how I could trace down dynamic NAT (by counting "built dynami...

dearsi have a aproblem with connection between ASA 5510 and WASS , after i am check another ASA 5520 that Support inspect WASS ,but i want to allow inspect WASS on ASA 5510 , so how can i solve this issue plzRegardsAlaa Jararha