Cisco ASA firewall/Router/Switch support SNMP v3 Read-Write ?

[velavan.r]

Hello

Cisco ASA firewall/Router/Switch support SNMP v3 Read-Write ?

thanks in advance

velavan

[julomban]

Hello Velavan,

The ASA supports traps and SNMP read access, but does not support SNMP write access.

I am not sure about the routers and switches but the ASA does not.

Regards,

Juan Lombana

Please rate helpful posts.

[Marvin Rhoads]

Adding to Juan's correct answer, the ASA does support SNMP v3 (read) since Version 8.2(1). If your software is older than that, only SNMP v1 or v2c will be supported (still read-only).

Configuration steps are listed in the guide here:

http://www.cisco.com/en/US/docs/security/asa/asa84/configuration/guide/monitor_snmp.html#wp1239780