cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
539
Views
0
Helpful
4
Replies

Cisco ASA NAT Question (Access DSL Modem Webinterface)

roesch4alc
Level 1
Level 1

Hi all,

Is there a way (without adding second cable between modem and asa!!) with Software 9.1.6 to setup a nat, that allows me to access the dsl modem´s webinterface?

Setup:

Internet<--->DSLModem<--->Cisco-ASA<--->LAN

The DSL Modem has an given ip address 192.168.1.1 with a webserver listening on port 80. The Cisco ASA 5505 has configured a vlan interface with "ip address pppoe setroute" and gets an ipv4 public ip address. Theres also a internal network, with a private ip range.

I would like to access the dsl modem´s webinterface with an hosting sourcing in the internet....

Best Regards

Sebastian

4 Replies 4

roesch4alc
Level 1
Level 1

Nobody?

I have found a link which might help to solve your problem, Please see below and let me know if it helps:-

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html

Farhan Mohamed
Cisco Employee
Cisco Employee

I have found a link which might help to solve your problem, Please see below and let me know if it helps:-

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118962-configure-asa-00.html

Hi,

I think this link actually provides no technical solution for my problem. But if you think there is a solution, please post an example config.

Thank you.

Review Cisco Networking for a $25 gift card