cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1568
Views
0
Helpful
2
Replies

Cisco ASA pinging tools.cisco.com using IPv4

latenaite2011
Level 4
Level 4

Hi Everyone,

 

Does anyone know how to force the Cisco ASA to ping tools.cisco.com using IPv4?  The WAN/External interface has both IPv4 and IPv6 configured and when pinging tools.cisco.com from the ASA directly, it defaults to IPv6, see below for output (actual address masked):

 

firewall# ping tools.cisco.com
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 20XX:XXX:XXXX:X::Xa, timeout is 2 seconds:
?????
Success rate is 0 percent (0/5)

 

Not sure how to make it use IPv4 and I think this is causing the Call-home feature to fail.

 

Thanks!

1 Accepted Solution

Accepted Solutions

This has been fixed by configuring a public DNS server. 

View solution in original post

2 Replies 2

latenaite2011
Level 4
Level 4

Looks like the call-home section doesn't have a http option to force it to use IPv4 or there is a way to configure a destination address with a fqdn using an IP address.

This has been fixed by configuring a public DNS server. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: