Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey everyone,
Does anyone know how to remove IPv6 DNS server from the DNS Trusted Source (DNS Server configured) and also any references to IPv6 when resolving FQDN on the firepower or passing through it (for data plan traffic)? I think it might be ...
Hey everyone,
Getting the following error while trying to launch the FDM API Explorer (trying to change the time zone):
I tried, https://x.x.x.x/api/api-explorer:
{"message":"Unauthorized","status_code":401}
I am running version 7.2.5-208.
Thanks!
L...
Hey everyone,
Just wondering if anyone knows where to send the Netflow collector on a cloud-based wireless controller (such as Meraki for example). Would we send it to an on-premise Netflow collector? If it is on-premise, would the Netflow be encry...
Hey Thomas,
Thanks a lot for this video. Have a question on the Split upgrade option. If we have six nodes to upgrade (2 x PANs, 2 x MNTs, and 2 x PSNx), can we go through the Upgrade Wizard and follow those steps and split the in several maintenan...
Does anyone know how to properly migrate the configurations and policies (and everything else) from the Cisco Secure Email Cloud Gateway (C100V) to the Fortinet Fortimail? Is there a migration tool?
Hey Marce1000,
Thanks a lot for your suggestion and sorry for the delay in responding.
Did further troubleshooting and it appears that the time in the FDM GUI is correct but in the CLI console, the time and timezone are off so not sure what the Firep...
Thank you M. for this suggestion. Seems pretty length and complicated tomake a small change.I am wondering if not having the correct time zone would impact theFirepower in some way if it uses FQDN on the firepower access policies,specifically this w...
Thank you Yosadanjel for the explanation.Follow up questions.Say in the case of Meraki or Junipr Mist cloud controller for example, ifwe send it on-premise, it probably wouldn't be good to send netflow data tothe Netflow collector on-premise as traff...
Hey Thomas,I went through this video but didn't see anything for the switchportconfiguration. What would the switch port configuration be for the802.1x/MAB for the Meraki AP?Thanks in advance!