Cisco Firepower Threat Defense for KVM (75) Version 6.2.0 (Build 363)

[nyeinchanzaw005]

Hi all,

  I setup firepower FTD in EVE-lab. I can ping from my host for firepower and i cannot access via web management. Any configurations need for web access ? 

Remark : when i run "configure manager local" it's showing "This device does not support local management".

[balaji.bandi]

depends on the setup, generally when you setting up intial the Manangement interface setup IP that used for GUI access.

if you setup locally managed, then you can use FDM, if you setup managed by FMC, then you need FMC - wipe the node and start over again.

below my setup using 7.0

https://www.balajibandi.com/?p=1855