11-29-2022 07:56 AM
Hello everyone,
I have a problem with my FPR, since no internet connection is established, kindly find attached photo which shows an overview of the FPR status,
Model: Cisco Firepower 1010 Threat Defense
Version: 6.4.0-102
Topology: Mikrotik port 2 connected the cisco FPR port 1, and then a cable from FPR port 3 connected to the switch port 23, ...
I have VPN access through the FPR, I also have ping to the Mikrotik, ping to 8.8.8.8, ping from/to the core switch, I already did all the routing and NATing needed (Note that the network was operating normally for 7 months till today, so I'm sure that the problem is not with the configuration)
I don't have ping to the internet from the switch!
I contacted the ISP, they are telling me that everything is fine from their side, so any suggestions ?
Best Regards,
B Osman
11-29-2022 08:02 AM
this config work only if your FW is transparent mode ? are you run FW as transparent mode??
11-29-2022 08:25 AM
11-30-2022 05:37 AM
At the end it was an ISP problem, I changed the public IP temporarily and the issue was resolved,
Thanks everyone
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide