Hi everyone,
I successfully configured Cisco FPR1010. Unfortunetly now I can not connect to FXOS.
FPR1010 boot directly to ASA code and when I want to connect from ASA CLI to FXOS i get that error.
The details you can see below. Can you give an advice how to solve this problem?
Thank you.
Mira
Error message:
asa01-NEW# connect fxos
Configuring session.
.....
ERROR: Unable to configure FXOS account.
Error connecting to FXOS
Type help or '?' for a list of available commands.
ASA details:
prg-asa01-NEW# dir all-filesystems
Directory of disk0:/
805306599 drwx 4096 15:42:44 Feb 11 2021 .private
231 drwx 4096 16:10:01 Feb 12 2021 log
539478057 -rw- 38925172 11:24:04 Jan 23 2021 asdm.bin
2 drwx 4096 10:47:49 Feb 09 2021 cores
539478071 -rw- 0 10:19:49 Feb 11 2021 coredumpfsysimage.bin
2 drwx 4096 10:47:49 Feb 09 2021 coredumpfsys
539478078 -rw- 39 10:52:41 Feb 11 2021 snortpacketinfo.conf
539478079 drwx 21 10:20:46 Feb 11 2021 smart-log
805306611 drw- 25 10:21:02 Feb 11 2021 coredumpinfo
539478068 drwx 6 10:19:49 Feb 11 2021 fxos
268435717 -rw- 1462 10:19:48 Feb 11 2021 cspCfg.xml
537178946 -rwx 7643 21:36:02 Feb 11 2021 running-config-cleared
5 file(s) total size: 38934316 bytes
16106127360 bytes total (15748612096 bytes free/97% free)
Directory of disk1:/
6 -rwx 410374960 14:51:02 Feb 10 2021 cisco-asa-fp1k.9.15.1.7.SPA
1 file(s) total size: 410374960 bytes
4000296960 bytes total (3589902336 bytes free/89% free)
asa01-NEW up 1 day 9 hours
Hardware: FPR-1010, 6766 MB RAM, CPU Atom C3000 series 2200 MHz, 1 CPU (4 cores)
Encryption hardware device : Cisco FP Crypto on-board accelerator (revision 0x11)
Driver version : 4.2.0
Number of accelerators: 6
1: Int: Internal-Data0/0 : address is 00a0.c900.0000, irq 10
3: Int: Not licensed : irq 0
4: Ext: Management1/1 : address is 549f.c6c5.5701, irq 0
5: Int: Internal-Data1/1 : address is 0000.0100.0001, irq 0
License mode: Smart Licensing
