Cisco FTD 2130

[Sharanjeet_Kumar]

Hello,

I have a Cisco FTD 2130. It gets in rommon mode every time I power on.

I tried to boot from USB, but it's getting into looop and boot failed.

Any help is appreciated.....

[balaji.bandi]

Can you post complete boot logs ?

[Sharanjeet_Kumar]

Hi @balaji.bandi ,

Here is a screenshot 

[balaji.bandi]

with that screenshot i am not able to figureout what is the issue

may check @Marvin Rhoads suggestions - see lucky

[MHM Cisco World]

Cisco FXOS Troubleshooting Guide for the Firepower 1000/2100 and Secure Firewall 3100 with Firepower Threat Defense - Reimage Procedures [Cisco Secure Firewall Threat Defense] - Cisco

this guide will help you
there is different in config for boot from USB.

[Sharanjeet_Kumar]

Hi @MHM Cisco World,

Already have this document.

Applied all this, but my issue is still same.

[MHM Cisco World]

rommon 1 > dir disk1:
rommon 2 > boot disk1:/cisco-ftd-fp2k.x.x.0.SPA

 you use this ?

[Marvin Rhoads]

I've seen these with an incorrect configuration register from the factory.

Try setting the value from rommon to tell it to boot from disk (“confreg 0x1”).